Filter
Top Products
Network Settings
4
C550 4-96
4.12 SNMP Settings
Specify SNMP settings. Settings can be specified for the following.
SNMP Setting screen 1/3
SNMP Setting screen 2/3
SNMP Setting screen 3/3
!
Detail
If an IP address or IPX address is specified with “Status Notification Set-
ting”, use the TRAP function with SNMP. Set “TRAP Setting” on the
SNMP Setting screen to “Allow”.
For details on “Status Notification Setting”, refer to “Status Notification
Setting” on page 4-125.
1 Touch [5 Network Setting] in the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
“Displaying the Administrator Settings screen” on page 3-7.
2 Touch [8 SNMP Settings] in the Network Settings screen.
SNMP Setting screen 1/3 appears.
Parameter Description
SNMP v1/v2c (IP) Select whether or not SNMP v1/v2c (IP) is used.
SNMP v3 (IP) Select whether or not SNMP v3 (IP) is used.
SNMP v1 (IPX) Select whether or not SNMP v1 (IPX) is used.
Parameter Description
UDP Port Number Specify the UDP port number. To change the setting, press the [C]
(clear) key, and then use the keypad to type in the desired port
number. (Range: 1 to 65535)
SNMP v1/v2c Settings Specify the settings when v1 or v2c is selected. For details, refer
to “SNMP v1/v2c Settings” on page 4-98.
SNMP v3 Settings Specify the settings when v3 is selected. For details, refer to
“SNMP v3 Settings” on page 4-100.
Parameter Description
Permission Settings Select whether to permit or prohibit TRAP.
TRAP Setting When Au-
thentication Failed
Select whether or not to enable TRAP when authentication failed.