Filter
Top Products
System Menu
3-23
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Administrator Management Code Change
You can change the four-digit management code for the administrator of this machine.
Important! • If you change the management code, be sure to note it. If you should forget the management
code, contact your service representative.
• The management code at the factory default setting is 1600 for the 16 ppm model, 2000 for
the 20 ppm model, and 2500 for the 25 ppm model.
1
Display the Machine default screen. (See How to Display the Machine Default Screen on
page 3-12.)
2
Press the S key or the T key to select PIN #
Change [MGMT Code entry].
3
Press the Enter key.
4
Use the numeric keys to input the new administrator
management code.
5
Press the Enter key.
6
Press the Reset key. The message display returns to the copier basic screen.
Auto Sleep
The machine enters automatically the sleep mode when the preset time elapses without any
operation if this setting is turned On.
Notes • This setting is displayed only on the inch specification machine.
• You can disable the auto sleep function if this function causes inconvenience. It is
recommended, however, to set a longer time that elapses before the auto sleep function is
activated, before disabling this function.
1
Display the Machine default screen. (See How to Display the Machine Default Screen on
page 3-12.)
2
Press the S key or the T key to select Auto Sleep.
3
Press the Enter key.
4
Press the S key or the T key to select On or Off.
Machine default:
Date/Time 08:48:
Display Contrast :
PIN # Change
Management code change:
1600
# keys
Machine default:
On:
Display Contrast :
PIN # Change
Auto Sleep
Auto Sleep:
Off
On
*