Kyocera DP-3600 Printer User Manual


 
Chapter 5 Troubleshooting
5-16
Message Corrective Action
MEMORYCARD err ##
Press CONTINUE
This message appears when an error occurs during access to the memory
card using the PRESCRIBE 2e RWER (ICCD) command or from the printer’s
control panel. Look at the error code given in place of
##
and refer to the
corresponding description given below. Note that only error codes
09
and
11
are displayed due to memory card operations made from the control panel.
01
:Data or memory card capacity is too large.
·
This error code appears if an attempt is made to write more than
32 MB of data to a memory card or if the capacity of the memory card
installed in the printer is more than 32 MB. Decrease the data being
written to the memory card to less than 32 MB. Note that only memory
card of 32 MB and less can be used by this printer.
·
This error code appears when a data name not existing on the memory
card is specified.
Check the data names on the memory card.
02
: The memory card does not meet specifications. This memory card
cannot be used by this printer. Insert a memory card which can be used by
this printer. (See “Memory Card” of
Chapter 2
.)
03
: The memory card is not supported by this printer.
Only JEIDA Ver. 4.2/PCMCIA Ver. 2.1 memory card can be used by this
printer.
04
: The card is an S-RAM or flash card which cannot be used by this printer.
05
: There is no battery in the memory card. Replace the battery in the
memory card with a new one.
06
: The memory card is write-protected. Cancel the write-protection of the
memory card.
07
: The memory card requires formatting. Format the memory card from the
control panel.
09
: The capacity of the memory card is insufficient. This error code appears
when an attempt is made to write more data on the memory card than
available memory. To halt the writing of data, first stop data transmissions
from the computer, and then the printer's
CANCEL
key. Press the
FORM
FEED
key if the message
Waiting
will appear in the message display. The
message display will return to reading
Ready
.
(Continued on next page)