Filter
Top Products
Input/Output
5 - 50 User Tools Settings
Input/Output
Switch to Batch (SADF)
You can select Batch mode or SADF mode when you press the Special Original key.
SADF Auto Reset
When you set one original at a time in the document feeder, the Auto Feed indicator lights for a
selected time after an original is fed to show that the document feeder is ready for another original.
You can adjust this time from 3 seconds to 99.
Default: 5 sec.
Rotate Sort: Auto Paper Continue
You can specify whether to continue copying when the paper of the required orientation has run
out during rotate-sorting.
“Sort”
•
If you select [No]:
When paper of the required orientation runs out, the machine stops copying and prompts
you to supply copy paper. When you load paper, the machine will continue copying.
•
If you select [Yes]:
Copying continues using copy paper of a different direction. The copy job will finish
even if you have left the machine.
Default: No
Auto Sort
You can specify whether Sort mode is selected when the machine is turned on or the mode is
cleared.
Default: No
Memory Full Auto Scan Restart
When the memory becomes full while scanning originals, the machine can make copies of the
scanned originals first, then automatically proceed scanning the remaining originals. You can
enable or disable this function.
•
If you select [No]:
When the memory becomes full, the machine stops operation allowing you to remove
the copy pages delivered on the output tray.
•
If you select [Yes]:
You can leave the machine unattended to make all the copies, but the resulting sorted
pages will not be sequential.
Default: No