Filter
Top Products
8. Squeeze the spring clips 1 on the sides of the front USB connector
assembly and pull the assembly out of the back of the housing.
9. Carefully pull the front USB cable out of the opening in the chassis.
10. If you are instructed to return the front USB connector assembly, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Removing the rear adapter retention bracket
To remove the rear adapter-retention bracket, complete the following steps:
1. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
2. Unlock and remove the side cover (see “Removing the side cover” on page 62).
3. Remove all adapters (if necessary) and place the adapters on static-protective
surface.
Note: You might find it helpful to note where each adapter is installed before
you remove the adapters.
4. Release the rear adapter-retention bracket by lifting up on the rear
adapter-retention bracket, and rotate the bracket partially toward the closed
position.
5. Grasp the bracket on one side at the hinge point and pull outward (while you
rotate the bracket slightly toward the front of the server) until the bracket is free
of the hinge pin; then, grasp the bracket on the other side at the hinge point,
pull outward until the bracket is free of the hinge pin, and remove the rear
adapter-retention bracket from the server.
Chapter 4. Removing and replacing server components 101