Filter
Top Products
Paper Menu
27
Using the MFP menus
Custom Bin Names
This menu item is used to define a custom name for each output bin based on a person or the type of print media assigned
to exit to a specific output bin.
Universal Setup
These menu items are used to specify the height and width of the Universal Paper Size. When the height and width for
Universal Paper Size are specified, the MFP uses the Universal setting like other paper sizes, including support for duplex
and n-up. For more information on n-up, see Multipage Print.
Menu item Purpose Values and descriptions
<user-defined
Custom Bin Name>
Specifies the custom name of output
bin <x>, where x is 1–10 based on the
MFP model or the optional finisher, if
one is attached.
[user-defined
name], such as:
Company’s bin
Lawyer’s bin
Mary’s bin
Stephen’s bin
The custom output bin must be able
to accept the type of print media
assigned to exit to the defined bin in
order for a user-defined name to be
assigned.
Menu item Purpose Values and descriptions
Units of Measure Determines the unit of measure
used to enter the Universal Height
and Width.
Inches
Millimeters
Inches is the US default, and
Millimeters is the international default.
Portrait Width Sets the portrait width of the
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
3–14.17 inches in
0.01 inch increments
76–360 mm in 1 mm
increments
Shows either inches or millimeters
from the Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
Portrait Height Sets the portrait height of the
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
3–14.17 inches in
0.01 inch increments
76–360 mm in 1 mm
increments
Shows either inches or millimeters
from the Units of Measure setting;
14 inches is the US default, and
356 mm is the international default.
Feed Direction Specifies the feed direction of the
Universal Paper Size.
Short Edge*
Long Edge
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
See Duplex Bind on page 77 for
more information about short and long
edges.