Filter
Top Products
Settings
86
Using the MFP menus
PCL Emulation
Settings
Changes the point size for scalable
typographic fonts.
Point Size
1.00–1008.00 (12*)
Point size refers to the height of the
characters in the font. One point
equals approximately 1/72 of an
inch. Point sizes from 1 to 1008 in
increments of 0.25 points can be
selected.
Note: Point Size only appears for
typographic fonts.
Specifies the font pitch for scalable
monospaced fonts.
Pitch
0.08–100.00 (10*)
Pitch refers to the number of fixed-
space characters in a horizontal inch
of type. A pitch from 0.08 to 100
characters per inch (cpi) in
increments of 0.01 cpi can be
selected. For nonscalable
monospaced fonts, the pitch appears
but cannot be changed.
Note: Pitch only appears for fixed, or
monospaced, fonts.
Determines how text and graphics
are oriented on the page.
Orientation
Portrait*
Landscape
Portrait prints text and graphics
parallel to the short edge of the
paper.
Landscape prints text and graphics
parallel to the long edge of the paper.
See Duplex Bind on page 77 for
more information about short and
long edges.
Determines the number of lines that
print on each page.
Lines per Page
1–255
60* (US)
64* (non-US)
The MFP sets the amount of space
between each line (vertical line
spacing) based on the Lines per
Page, Paper Size, and Orientation
menu items. Select the correct Paper
Size and Orientation before changing
Lines per Page.
Sets the width of the logical page for
A4 size paper.
A4 Width
198 mm*
203 mm
Note: The 203 mm setting makes
the logical page wide enough to print
eighty 10-pitch characters.
Specifies whether the MFP
automatically performs a carriage
return (CR) after a line feed (LF)
control command.
Auto CR after LF
Off*
On
Off—The MFP does not perform a
carriage return after a line feed
control command.
On—The MFP performs a carriage
return after a line feed control
command.
Specifies whether the printer
automatically performs a line feed
after a carriage return control
command.
Auto LF after CR
Off*
On
Off—The MFP does not perform a
line feed after a carriage return
control command.
On—The MFP performs a line feed
after a carriage return control
command.
Menu item Purpose Values and descriptions