Filter
Top Products
Settings
82
Using the MFP menus
Setup Menu
Use the Setup Menu to configure a variety of MFP features.
Job Acct Stat Prints a listing of all job statistics
stored on the hard disk or clears all
statistics on the hard disk.
Warning: Clear appears as a value
only if Job Accounting is not set to
MarkTrack™.
Note: This menu item only appears if
the hard disk is not write or read/write
password protected.
Print Prints all statistics available for the
most recent print jobs.
Clear Deletes all accumulated job
statistics from the hard disk. As the
MFP deletes all stored job
statistics, the message Clearing
job accounting statistics
appears as the jobs are deleted.
Activate Hex
Trace
Helps isolate the source of a print job
problem. With Hex Trace selected, all
data sent to the MFP is printed in
hexadecimal and character
representation. Control codes are not
executed.
Touch Activate Hex Trace to enter
Hex Trace mode.
To exit Hex Trace mode, turn the
MFP off, wait 15 seconds, and then
turn the MFP on.
Coverage
Estimator
Provides an estimate of the
percentage of coverage of cyan,
magenta, yellow, and black on a page.
The estimate is printed on a separator
page.
Off* Percent coverage is not printed.
On Prints the estimated percentage of
coverage for each color on the
page.
Menu item Purpose Values and descriptions
Printer Language Specifies the default printer language
used to communicate data from the
computer to the MFP.
Note: Setting a printer language as the
default does not prevent a software
application from sending print jobs that
use the other language.
PCL Emulation*
PS Emulation
PCL emulation—Uses a
PCL interpreter for
incoming host
communications.
PostScript emulation—
Uses a PS interpreter for
incoming host
communications.
Resource Save Specifies what the MFP does with
downloaded resources, such as fonts
and macros stored in RAM, if the MFP
receives a job that requires more
memory than is available.
Setting Resource Save to On causes
the MFP to reset and returns the LCD
to the home screen.
Off* The MFP retains
downloaded resources only
until memory is needed. It
then deletes those
resources associated with
the inactive printer
language.
On The MFP retains all
downloaded resources for
all printer languages during
language changes and
MFP resets. If the MFP
runs out of memory, 38
Memory Full appears.
Menu item Purpose Values and descriptions