Filter
Top Products
Installation Drawings
17
7.0 INSTALLATION DRAWINGS
Figure 5 Outline drawing: 100 – 250 amp STS2
GRAVITY
SIDE VIEW
TOP VIEW
BOTTOM ENTRY AREA
POWER CABLE
BOTTOM ENTRY AREA
CONTROL CABLE
BOTTOM VIEW
FRONT VIEW
EXHAUST
TOP ENTRY AREA
TOP ENTRY AREA
POWER CABLE
CONTROL CABLE
FRONT
FRONT
MAX. DOOR SWING 180°
CENTER
GRAVITY
CENTER
SEE DETAIL A
CENTERS
CASTER
CENTERS
12MM
AIR
CENTERS
CASTER
12MM CENTERS
AIR
FILTER
AIR INTAKE AREA
DO NOT
BLOCK
OUTLINE DRAWING
100 - 250 AMP
STATIC TRANSFER SWITCH 2
DETAIL A
WITHOUT SIDE PANEL
FRONT OF UNIT SHOWN
(SEE NOTES
10)
12MM DIA
THREADED
MOUNTING
HOLE (4) TYP
LEVELER
NOTES:
1. ALL DIMENSIONS ARE IN INCHES AND MILLIMETERS.
2. 18” (457MM) MIN. CLEARANCE ABOVE UNIT REQUIRED FOR AIR EXHAUST.
3. INSTALLATION AND SERVICE ACCESS REQUIRED IN FRONT ONLY.
4. HEAT OUTPUT: 2710 BTU/HR (0.80 KW/HR) MAX. FOR 100A SWITCH.
4680 BTU/HR (1.37 KW/HR) MAX. FOR 250A SWITCH.
5. WEIGHT - 780 LBS. (354 KG).
6. UNIT BOTTOM IS STRUCTURALLY ADEQUATE FOR FORKLIFT HANDLING.
7. KEEP CABINET WITHIN 15 DEG. OF VERTICAL WHILE HANDLING.
8. COLOR - IBM OFF WHITE.
9. OPEN DOOR TO REPLACE AIT FILTER, DISPOSABLE TYPE, SIZE 1X25X25.
10. THREADED MOUNTING HOLES (SEE DETAIL A) ARE PROVIDED FOR SEISMIC
ANCHORING OR FLOOR STAND. MOUNTING BOLTS MUST BE THREADED INTO
THE UNIT MOUNTING HOLES FROM UNDERNEATH THE UNIT BASE. IF FLOOR
STAND IS USED, THE CASTERS MUST REST ON THE FLOOR STAND TO
SUPPORT THE WEIGHT OF THE UNIT.
PS211100 REV. NO. 2
(762)
30
(932)
36.7
(477)
18.8
(1956)
77.0
(488)
19.2
(620)
24.4
(238)
9.4
(343)
13.5
(326)
12.8
(130)
5.1
(756)
29.8
(619)
24.4
(265)
10.4
(376)
14.8
(272)
10.7
(548)
21.6
(736)
29.0
(594)
23.4
(280)
11.1
(213)
8.4
(116)
4.6
(546)
21.5
(815)
32.1
(69.8)
2.75 (TYP)