Filter
Top Products
Installation Drawings
40
Figure 28 Control wiring for the network interface card (NIC) option
PS213005
REV. 2
NETWORK INTERFACE
CARD (NIC) 416241GX
AND LOCAL ELECTRICAL CODES.
LIMITED BY INTERNET STANDARDS.
6. ALL WIRING MUST BE IN ACCORDANCE WITH NATIONAL
OF STATIC TRANSFER SWITCH FOR LOCATION OF NETWOR
K
5. REFER TO CONTROL CONNECTION LOCATION DIAGRAM
SEPARATE FROM POWER WIRING. CONTROL WIRING RUNS
4. ALL CONTROL WIRING (BY OTHERS) MUST BE RUN
SHOULD NOT BE COMBINED IN THE SAME CONDUIT.
MANUAL FOR CONFIGURING THE NETWORK INTERFACE
3. REFER TO INSTALLATION, OPERATION & MAINTENANCE
1. WIRE SIZE AND TYPE: 10/100 BASE-T ETHERNET
CABLE WITH RJ45 PLUG CONNECTOR. THE LENGTH IS
NOTES:
INTERFACE CARD OPTION.
132
TB2
P18
J3
ETHERNET NETWORK
RJ-45 CONNECTOR
SEE NOTES 1 & 2
CUSTOMER SUPPLIED
INTERCONNECTING CABLE
+
-
CUSTOMER SUPPLIED
INTERCONNECTING
CABLE TO MODBUS
SEE NOTE 2
WITH TWISTED PAIR CABLE #22 AWG MINIMUM. SIGNAL
2. MAXIMUM CABLE LENGTH 1000 FEET (300 METERS)
VOLTAGE 5VDC, CURRENT 10mA.
RS-232 (DB9
CONNECTOR) FOR
SETUP ONLY. USES
STANDARD COMPUTER
SERIAL PORT CABLE
CARD (NIC).
"NO CUSTOMER
CONNECTION"
"NO CUSTOMER
CONNECTION"