Liebert POWER PROTECTION STATIC TRANSFER SWITCH Switch User Manual


 
Operating Instructions for the Touch Screen Interface
64
10.0 OPERATING INSTRUCTIONS FOR THE TOUCH SCREEN INTERFACE
After the initial equipment start-up, the following operating guidelines can be used for standard
equipment operation. These guidelines should be reviewed for any special equipment modifications,
special site conditions, or company policies that may require changes to the standard equipment oper-
ation.
All programmable functions are preset at the factory to enable the unit to be brought up without the
need to enter all selectable parameters.
This section refers to the LCD touch screen display. This display is discussed in more detail later in
the manual. See 13.0 - STS2 Touch Screen Display.
See Figures 14- 19 for circuit breaker locations.
!
CAUTION
Before unit is placed into service for the first time, after equipment relocation, or after the
equipment has been de-energized for an extended period of time, a thorough equipment
inspection and supervised start-up by qualified personnel are strongly recommended. Contact
your local Liebert representative or Liebert Global Services at 1-800-543-2378 to arrange for
equipment inspection and start-up.
NOTE
If the front panel of your STS2 is comprised of LEDs and push buttons instead of the touch
screen interface, refer to 14.0 - Operating the LED Display STS2 for operating instructions.