Filter
Top Products
α
2 Simple Application Controllers
SMS/SMR/CD Functions and the Modem Setting 2
2 - 7
After the Input Pin is turned OFF, the Word Output will also be reset to 0 when the
communication is complete.
Note:
The Word Value will display a hexadecimal number. Convert the hexadecimal number to
binary form to check the values against Table 2.5 Output Word Value parameters. It is possible
that multiple bits will be ON simultaneously.
The status of the entire controller can be seen in the Diagnosis of Controller dialog box
described in Chapter 4.
Note:
Transmission of UCS2 encoded short messages to an email account is not necessarily sup-
ported for a SMS Gateway. In the event no support by the SMS Gateway, UCS2 encoded short
messages cannot be sent to an email account and a fax machine.
Please contact the used GSM network provider.
2.2.1 The Short Message Service (SMS)
The Short Message Service dialog box is used to choose whether to send the SMS message
to a mobile phone or an e-mail address. If an e-mail message is chosen, the address is
entered in the E-mail entry block at the bottom of the box.
Only one e-mail address can be
entered per GSM/SMS Function Block
.
A) Comment
Input a comment to label the function block. The comment will be shown on the VLS software
display if the “D
isplay Comment” block is checked.
B) Display Signal Number
Check this box to display the Function Block number on the VLS software display.
)
)
)
)
)
)
B
C
A
D
E
F