Filter
Top Products
α
2 Simple Application Controllers
AL-PCS/WIN-E Settings for Dedicated Protocol 6
6 - 5
D) Communication Function Block Word Device
To set a Communication Word Device choose a number in the right hand “Communication
Word Device” block, then highlight the Function Block in the “FB Word Output parameter to be
specified” box. Click on the “Set” button to match the Function Block to the data transmission
address.
To release a Communication Word Device, highlight the Parameter line in the right hand box
and then press the “Release” button. The Communication Word Device will be cleared.
The transmit data will show the word value of the parameter chosen.
Function Block without Word parameters will not appear in the display.
Note:
No devices can be chosen if the Communication Memory is specified as 0
.
After the parameters are entered, the program must be downloaded to the controller and the
power cycled before the Dedicated Protocol can be used. Cycling the power saves the settings
into the
α
2 internal EEPROM memory. Please cycle the power whenever the communication
method (Not Use, Modem, GSM, Other) is changed.