Filter
Top Products
α
2 Simple Application Controllers
AL-PCS/WIN-E Settings for Dedicated Protocol 6
6 - 12
6.3.8 Default
The default values are DataLength = 8 bits; Parity = None; Stop Bit = 1 bit; and
Baud Rate = 9600 bps.
6.3.9 Station Number
Set the Station Number of the controller from 0 to 15. The default
station is 0.
Communication is possible to a single
α
2 Controller when sending
messages via RS-232. A networked PLC might have a station number
higher than 0.
6.3.10 Link Block
The Link Block setting specifies the amount of Function Block data that
can be used in the Dedicated Protocol. The data for the three options is
given in the table below.
Note
The user must not change the memory allocation for Communication BIT/WORD device during
the computer link operation, otherwise, the settings created in the VLS software will be
deleted.
6.3.11 Function Block Bit and Word Data
The Function Block data must be given addresses in memory for the Dedicated Protocol
command string. The addresses can only be set in the VLS software.
Table 6.3: Link Block Settings
Link
Number
Communication
Bit Devices
Communication
Word Devices
00 0
150 50
2 100 100
Oth r C
Stat i
moe
on No
No . 0
Oth r C moe
Lin l kokb c
2