Filter
Top Products
α
2 Simple Application Controllers
AL-PCS/WIN-E Settings for Dedicated Protocol 6
6 - 7
Time
Switch m
[TSm]
The Time Switch maintenance Function
Block uses a predefined time schedule to
control the ON and OFF status of the
output. The function block can be setup
from the TopMenu “Parameter” via the front
panel keys.
*1
Counter
[CN]
The Counter Function Block increments the
current value by one as and when the input
pin receives a signal. When the current
value reaches the set value the output is set
ON. The counter current value is reset as
and when the clear pin receives an input.
Count
Current Count
U/D
Counter
[UD]
The Up/Down Function block positively or
negatively increments the counter until a
set value is reached thereby setting the
output ON. A preset signal can also equal
the set value regardless of the current value
for the function block and thereby setting
the output ON.
Up/Down Count
Current Up/Down Count
Compare
[CP]
The Compare Function Block monitors the
current value of the input pin in relation to a
preset expression. The expression consists
of =,>,>=,<,<= or <>. If the compared value
satisfies the expression subsequently the
output pin is set on.
-
Analog
Ouput
[AO]
The Analog Output function takes a digital
value input and delivers a corresponding
analog voltage or current to a selected
channel on the AL2-2DA module.
--
Offset
Gain
[OG]
The Offset Gain Function Block is based
upon a linear function Y=A/B
∗
X+C to which
the value obtained from an analog input
(X:A01-A08) is set.
Gain Analog Value -
Display
[DP]
The Display Function Block is used as an
interface between the user and the devices
held within the controller. Current values,
timer messages, user-defined messages
can be read.
--
Zone
Compare
[ZC]
The Zone Compare Function Block
identifies whether the input value lies within
a specified upper and lower limited zonal
area and if so changes the status of the
output accordingly.
-
Schmitt
Tr i g g e r
[ST]
The Schmitt Trigger Function Block
compares an input value to preset high and
low limits. The output is ON when the input
value reaches the high limit and then falls
below the lower limit. The function only
processes the data when the function block
is receiving an input signal.
-
FB Name FB Symbol Description of Function Block Word Device
Bit
Device
000
TSm
O
P
000
NC
OI
C
P
000U
DU
OD
C
P
P
000
PC
OI P
000
O
A
M P
E
000
GO
I P
000
PD
I P
000
CZ
OI P
000
TS
OI P