Filter
Top Products
SDP-Eco1630 III USERS MANUAL
- 28 -
4) Inputting the value for the remaining amount of plate (61m to 46m)
Press the key or the key to
move the cursor to the remaining
amount display. Press the key or
the key to start the cursor
flashing. Change the remaining
amount using the key or the
key and register the value with
the key.
*Press the key to return to the original menu when you finish changing settings.
4.5 Execution of Pre. Feed command (This procedure is necessary
when loading the plate.)
Close the plate setting cover after the plate roll is set.
(1) Return the menu to the upper level menu using the key.
(2) Select Pre. Feed (preliminary feeding mode) using the key.
Press the key to move to the lower level menu
for the preliminary feeding mode.
(3) Use the key to set the plate feeding number to either "1" or "3" -- for
"Feed Count 1".
(4) Start preliminary feeding with the key.
- Press the key after the preliminary feeding. Press the key once to
call up the display. Press the key once more to call up the
display and switch to the on-line mode.
- Normally, a preliminary feeding must be performed to remove the fogged area
after loading a new plate.
Start OK
MENU
< Plate Data >
MENU
Note
MENU
< Plate Data >
MENU
M3 F175 414 61m
M3 F175 414 41m