Filter
Top Products
SDP-Eco1630 III USERS MANUAL
• The alarm function in this machine has been set to OFF before shipment at
the factory.
(Settings 000 = OFF)
• The consumption rate of rinse water may be different depending on the
settings in the machine. Set the consumption rate with the following
procedure.
[Procedure] (In cases where the current values are changed to "150".)
(1) Push the key to display the window.
(2) Select with the key, and then push the key.
(3) When is displayed, make sure that the cursor is placed
under the setting, and then push the key.
(4) Push either the key (Increase) or the key (Decrease) to set the
settings to "150".
(5) After changing the setting, push the key to confirm the setting.
(6) Push the key two times to display the window.
Use "120 to 160" as a reference value. Adjust the rate of rinse water reduction
depending on the installation conditions of the machine.
(Adjustable range: 50 to 300. Note that using "000" deactivates this function.)
[Notes for adjustment]
(1) When the "Rinse Tank Check" message is displayed.
If the replenishing bottle is empty, decrease the setting.
If there is a lot of rinse water left in the bottle, increase the setting.
(2) To deactivate the software counter function, use "000" as a setting value.
Be sure to reset the counter by "CLR" after you have adjusted the setting.
Note
< Plate Data >
MENU
Count 150 CLR
< Rinse >
< Plate Data >
MENU
- 46 -