Filter
Top Products
Message Error contents
ME9 A problem occurred in the heat roller. Please contact the
dealer where you purchased this machine.
ME10 A problem occurred when the punch unit was activated.
Please contact the dealer where you purchased this
machine.
ME11 A problem occurred in the laser adjustment unit. Please
contact the dealer where you purchased this machine.
Punch Un-mounted The punch is not mounted.
Close front door The front door is open. Shut the door.
Width not enough The width of the plate is insufficient for the exposure
width. Replace the plate with one as wide as the
exposure.
Image Error An internal data transmission error occurred in the SDP-
Eco 1630 III. Re-boot the machine.
If this error occurs frequently, please contact the dealer
where you purchased this machine.
Plate Set error The plate has not been set correctly. Re-set the plate.
Plate End The plate ran out. Load a new plate.
Pick up plate Open the front door and remove a strip type plate
through the plate removal port.
Waste Tank Check The waste chemical tank is full.
Empty EAC The EAC chemical ran out. Replenish it.
Empty EST The EST chemical ran out. Replenish it.
Tray check The overflow tray has not been set. Set the tray.
I/F error4 An error has occurred in the SCSI communication. If the
error frequently occurs even after the system has been
rebooted, contact your local dealer where you purchased
this machine.
Please set plate A plate has not been set. Set the plate.
SRAM BOARD ERR #1 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SRAM BOARD ERR #2 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SRAM BOARD ERR #3 A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
NO SUPPORT DIMM A problem occurred in the memory module for buffer.
Please contact the dealer where you purchased this
machine.
MEM VERIFIY ERR A problem occurred in the memory module for buffer.
Please contact the dealer where you purchased this
machine.
3.3V REG. ERR NN A problem occurred in the I/F board. Please contact the
dealer where you purchased this machine.
SDP-Eco1630 III USERS MANUAL
- 70 -