Filter
Top Products
SDP-Eco1630 III USERS MANUAL
• Removing Plate jam 3
- Plate jam3 is displayed when the plate is not discharged.
1) Press the key. This stops the
buzzer and returns the cutter to its
home position.
2) Open the front door and remove
the cutter cover.
3) Remove the plate in the transfer
section.
4) If the plate is not in the transfer
section, remove the processor
rack.
5) If the processor rack cannot be
removed, cut the visible plate
using a cutting bar.
Do not use the cutting bar
except to cut and remove
jammed plates. After
using the cutting bar,
store it in the designated
location with its cap on.
6) Remove the processor rack and
then the plate.
7) With the processor rack removed,
close the front door and run the
processor. Remove the plate
discharged from the roller after the
processor stops running.
8) Re-set the processor rack.
Caution
- 72 -
Cutting bar
Cover for the plate
removal port
Plate removal port