Filter
Top Products
SDP-Eco1630 III USERS MANUAL
- 30 -
(2) Exposure
1) Press the key to call up display. Move the
cursor to the Laser Test Expo. display and press the key.
2) After Laser Test Expo. display appears, Y N is displayed. Choose
'Y' with the cursor key and press the key. The laser test
exposure will start. (Refer to '6-2 Laser menu')
- When the cursor key is at 'N', press the key to call up the
display.
- After completion of the test exposure, press the key once to call up the
display and press the key oncemore to return to .
- When re-adjustment of the light intensity is necessary, change the light
intensity value following step (1)-6 in the procedure above.
[Exposure Clear]
The image data which remains in the hard disk drive will be re-exposed if
exposure is interrupted during remote exposure (e.g., because of a plate end
signal). It is possible for the hard disk to keep up to 2 separations of image
data. Image data that has been exposed can be re-exposed.
1. Press the key to call up the display.
2. Select the key and press the key to move to the display
for re-exposure.
3. Select in the display. Pressing the key
shows the display for selecting unexposed or exposed data.
4. Pressing the key in the display brings up the
display.
Unexposure EXEC............Image data on the hard disk drive, which has not
yet been exposed.
Exposed EXEC.................Image data which has already been exposed.
Select EXEC and press the key to start
exposure.
5. Select and press the key to erase image data on the
hard disk drive.
- When is displayed, use the key (the red reset key)
to return to the previous window. Then press the key to return to the
window.
- Though the hard disk drive can keep image data for up to 2 separations, you
cannot select the separation data to be output.
< Plate Data >
MENU
Non Exposure Data
Note
Exposure Clear
<Exposed EXEC
Unexposure EXEC>
Exposure Clear
Exposure
< Image Data >
< Plate Data >
MENU
Start OK
MENU
<Laser>
MENU
Laser Test Expo.
Note
Laser Test Expo.
MENU