Filter
Top Products
SDP-Eco1630 III USERS MANUAL
- 34 -
4.8 Collecting exposed plates
Exposed plates are discharged into the plate receiving tray. The SDP-Eco
1630 II discharges plates image-side down. Adjust the length of the discharge
retainer arm to accommodate the maximum length of the plates used.
It is possible to continuously collect plates (up to 50 consecutive sheets).
However, we cannot guarantee trouble-free collection of such large
numbers of plates if the machine is indiscriminately discharging plates of
different lengths or if the plate type is frequently being changed.
4.9 Turning OFF the power supply and inspection at shutdown
Always, before shutting down the machine, press the power ON/OFF key to
perform the final inspection. When is displayed in the on-line mode,
press the key to return to the local mode and then press the power
ON/OFF key.
The required final inspection includes checking the chemical level in the
waste chemical tank and releasing the plate nip by turning the nip roller
clearance handle to its vertical position. Roller cleaning is also performed
during the final inspection. If this procedure is not followed, transfer errors
may occur or masters exposed on the following day may be stained or marred.
If this procedure is not followed, transfer errors may occur or plates exposed
on the following day may be stained or marred.
It is not necessary to turn ON/OFF the main power for a weekday shut-down.
For weekend inspections: at shut-down, first turn OFF the machine,
completely clean the roller, and finally turn OFF the main power supply (at
the breaker).
MENU
Start OK
Caution
4) To rotate the roller, turn the handle
in the direction indicated by the
arrow in the figure.
Rotate the roller with the handle.