Mitsubishi Electronics SDP-ECO 1630 III All in One Printer User Manual


 
SDP-Eco1630 III USERS MANUAL
Switch the mode between remote and local
Remote Mode Local Mode
Start OK <Plate Data>
Shift between commands (Example)
1st hierarchy <Maintenance>
2nd hierarchy Cutter Processor> <Ver SCSI-ID>
Command execution
There are two types of commands: one which activates machine functions
such as preliminary feeding and cutter-processor commands, and one which is
used, for example, to set numerical values.
For commands in which numerical values can be changed (Example:
Referring to P27 "4.4 Data input for the set plate")
Use the to move the cursor to the numerical value display. Press the
key to start the display flashing and change the displayed value. (In
some modes the numerical value display starts flashing from the time it is first
displayed.)
The or key increases/decreases a numerical value.
Press the key when the desired number appears.
If you wish to reset a value or interrupt the setting procedure, press the
key to return to the upper menu level without changing the currently set value
and re-start the setting procedure from the beginning by selecting the same
command.
For commands in which numerical values can not be changed (Example:
Referring to P28 "4.5 Execution of Pre. Feed command")
Use the to select the desired command. Then press the key to
execute it.
Repeatedly press the key until Start OK is displayed to return to the on-
line mode.
- 40 -