Filter
Top Products
4-6 SENDING FAXES
Real-time transmission (non memory transmission)
Your machine will simply dial the other fax and when it makes contact, your machine
will feed the document through, scanning and transmitting real time
• With real time transmission, you can watch each page as it is scanned and sent.
To perform a real time transmission:
1
Switch to the Fax mode by pressing [COPY
FAX
SCAN].
2
Place the document on the ADF.
NOTE: • The document glass cannot be used for real time transmission.
• The document glass is available only for the MFX-1330 .
3
Obtain a dial tone, either by:
• Pressing [Advanced Functions] repeatedly until “Monitor” appears, and then press
[Enter.]
– or –
Pressing the "Monitor" soft key
–or–
• Lift the handset if you have connected an external telephone to your machine.
In either case, the machine shows:
** Tel Mode **
_
– or –
Press [Advanced Functions] repeatedly until “Memory Tx” appears and press
[Enter]. Then select “Off” and press [Enter] to turn off the memory transmission.
– or –
If you assigned “Memory Tx” to a soft key (page 8-2), turn off the memory transmission
by simply pressing that key.
NOTE: “Monitor” is a default soft key on the F-300.
4
Dial the fax number.
• Use the numeric keys to dial the number.
–or–
• Press a one-touch key. (See page 3-6.)
–or–
• Press [Speed Dial /Group] and three-digit code. (See page 3-8.)
–or–
• Use the phone directory dialing. (See page 3-11.)
NOTE: With real time transmission, only one destination can be dialed.
5
When you hear fax tones from the remote unit, press [Start].
If a person answers the phone, use the handset to tell that person that you are trying
to send a fax. When you hear fax tones, press [Start].
If the call fails and you used “Monitor” to dial, p
ress [Advanced Functions] repeatedly
until “Monitor” appears, then press [Enter] or press the “Monitor” soft key
to hang up.
If you are using the handset, hang up after pressing [Start].
NOTE: To cancel the transmission, use Review commands features. (page 4-8)