Filter
Top Products
© National Instruments Corporation 2-1 NI CVS-1450 Series User Manual
2
Setup and Configuration
This chapter provides instructions for setting up the NI CVS-1450 Series
hardware. This chapter also includes instructions for installing software,
configuring an IP address, and acquiring an initial image using the
application software.
Required Items
The following items are necessary for setting up the CVS-1450 device.
Hardware
❑ CVS-1450 device
❑ Ethernet-equipped development computer running
Windows 2000/XP/Me/98
❑ DCAM-compliant IEEE 1394 camera
❑ IEEE 1394 jackscrew-to-latch cable (part number 778796-01) or any
standard IEEE 1394 cable—Facilitates plug-and-play connection from
the CVS-1450 device to up to three 1394 cameras. You can use a 4-pin
to 6-pin converter cable with cameras that have their own external
power supply and do not require power from the 1394 bus.
Note To maintain signal integrity, the IEEE 1394 cable length must be no longer
than 4.5 m.
❑ NI desktop power supply (part number 778794-01) or any
24 VDC ±10%, 50 W power supply
– Power supply cord—Connects the NI desktop power supply to an
outlet. Refer to
ni.com for the part number specific to your region
and ordering information.
– 4-position power connector—Required if you do not use the
NI desktop power supply