Filter
Top Products
Chapter 2 Setup and Configuration
NI CVS-1450 Series User Manual 2-16 ni.com
Installing the LabVIEW Real-Time Module, Vision Development
Module, and NI-IMAQ for IEEE 1394 Cameras
Note You must install LabVIEW, the LabVIEW Real-Time Module, and the Vision
Development Module software before installing the NI-IMAQ for IEEE 1394 Cameras
driver software.
Complete the following steps to install LabVIEW, the LabVIEW
Real-Time Module, the Vision Development Module, and NI-IMAQ for
IEEE 1394 Cameras onto the development computer.
1. Insert the LabVIEW CD into the CD-ROM drive.
2. When the installation splash screen appears, click Install LabVIEW,
and follow the setup instructions.
3. Insert the LabVIEW Real-Time Module CD into the CD-ROM drive.
4. When the installation splash screen appears, click Install LabVIEW
Real-Time Module, and follow the setup instructions.
5. Insert the Vision Development Module CD into the CD-ROM drive.
6. When the splash screen appears, click Install Vision Development
Module, and follow the setup instructions.
7. Insert the NI-IMAQ for IEEE 1394 Cameras CD into the CD-ROM
drive.
Note If you select the custom software installation, make sure to install the support for the
CVS-1450 Series.
8. When the splash screen appears, click Install NI-IMAQ for
IEEE 1394 Cameras, and follow the setup instructions.
9. When prompted, click Yes to restart the development computer.
Configuring the IP Address using the LabVIEW Real-Time Module
To set up an IP address for the CVS-1450 device, complete the following
steps:
1. Open the Measurement & Automation Explorer (MAX) configuration
software by double-clicking the MAX icon on the desktop, or navigate
to MAX by selecting Start»Programs»National Instruments»
Measurement & Automation.
2. Expand the Remote Systems branch of the configuration tree, and
click 192.168.10.12 to display the Network Settings window.
This IP address is assigned to all unconfigured CVS-1450 devices.