National Instruments NI CVS-1450 Series Switch User Manual


 
Chapter 2 Setup and Configuration
NI CVS-1450 Series User Manual 2-6 ni.com
Examples of Installation Category II are measurements performed on
household appliances, portable tools, and similar products.
Measurement Category III is for measurement performed in the
building installation at the distribution level. This category refers to
measurements on hard-wired equipment such as equipment in fixed
installations, distribution boards, and circuit breakers. Other examples
are wiring, including cables, bus-bars, junction boxes, switches,
socket-outlets in the fixed installation, and stationary motors with
permanent connections to fixed installations.
Measurement Category IV is for measurements performed at the
primary electrical supply installation (<1,000 V). Examples include
electricity meters and measurements on primary overcurrent
protection devices and on ripple control units.
Setup Overview
Figure 2-1 illustrates the sequence for setting up and getting started with
the CVS-1450 device.
Figure 2-1. Setup Sequence
or
or
Set Up the Development
Computer Using
Vision Builder AI
Set Up the Development
Computer Using LabVIEW
Real-Time with the Vision
Development Module
Acquire an Image Using
Vision Builder AI
Acquire an Image Using
LabVIEW Real-Time with the
Vision Development Module
Set Up the Hardware