Filter
Top Products
144 A Appendix
Printing
When [LPD Spool] is set to [Hard Disk] or [Memory]
The printer cannot receive any print data if the size of the data is bigger than the available
capacity in its hard disk or memory.
Note
• Depending on the type of computers, the print data may be sent again immediately when the data
volume exceeds the receiving capacity. This means that the computer is backing up data. To solve this
problem, cancel the print job at the computer.
When [LPD Spool] is set to [Off]
The printer cannot accept print jobs from two different computers at the same time.