Filter
Top Products
70 4 Settings on the Control Panel
Port9100
Select this to use Port9100.
nPort Status
Specifies whether to enable or disable the Port9100 port when the printer turns on. The
default is [Enable], which means the Port9100 port is available.
Note
• To enable the Port9100 port, the IP address must be set.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
nPrint Mode
*1 (refer to P. 83)
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [ESC/P] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type.
nPJL
*2 (refer to P. 83)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
nConnect Time-Out
*3 (refer to P. 83)
Specifies the time interval for disconnection when no further data is received. You can
specify a value between 2 and 65535 seconds in increments of 1 second. The default is [60
Secs].
nPort No.
Set the port number to 9100 or a value between 8000 and 9999. The default is [9100].
nTBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
The default is [Disable].