Filter
Top Products
4.2 Description of Menu Items 71
UPnP
Makes settings for UPnP (Universal Plug and Play).
nPort Status
Specifies whether to enable or disable the UPnP when the printer turns on. The default is
[Disable].
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
SNMP
Set this to use SNMP. SNMP are required to use the application that remotely controls
multiple printers. The printer information is maintained in SNMP. The application obtains the
printer information from the SNMP.
nPort Status
Specifies whether to enable or disable the SNMP port when the printer turns on. The default
is [Enable], which means the SNMP port is available.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
nTranspt Protocol
Specifies the transport protocol used for SNMP. IPX, UDP, or both protocols can be
specified. The default is [UDP].
Note
• When using UDP, both the IP addresses of a computer and the printer are required.
• Refer to the application's manual for the protocol to be used: IPX or UDP.
nCommunity (R)
* No.1 to 3 characters of 4 are available (refer to P. 83)
Specify the community name used for reading the printer management information (MIB)
with up to 12 alphanumeric characters. The default is [Unregistered].
nCommunity (R/W)
* No.1 to 3 characters of 4 are available (refer to P. 83)
Specify the community name used for reading/writing the printer management information
(MIB) with up to 12 alphanumeric characters. The default is [Unregistered].
nCommunity (Trap)
* No.1 to 3 characters of 4 are available (refer to P. 83)
Specify the community name used for trapping with up to 12 alphanumeric characters. The
default is [Unregistered].