Filter
Top Products
4.2 Description of Menu Items 65
nConnect Time-Out
*3 (refer to P. 83)
Specifies the time interval for disconnection when no further data is received. You can
specify a value between 2 and 3600 seconds in increments of 1 second. The default is [16
Secs].
nTBCP Filter
Specifies whether to enable or disable the TBCP filter when processing PostScript data.
The default is [Disable].
nPort No.
Set the port number to 515 or a value between 8000 and 9999. The default is [515].
NetWare
Select this to use NetWare.
nPort Status
Specifies whether to enable or disable the NetWare port when the printer turns on. The
default is [Disable]. To use NetWare, set this to [Enable].
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
nTranspt Protocol
Specifies the transport protocol used for NetWare. IPX/SPX, TCP/IP, or both protocols can
be specified. The default is [TCP/IP,IPX/SPX].
Note
• When using TCP/IP, both the IP addresses of a computer and the printer are required.
nPrint Mode
*1 (refer to P. 83)
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [ESC/P] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type.
nPJL
*2 (refer to P. 83)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
nNo. of Searches
*3 (refer to P. 83)
Specifies how many times the file server is searched.
Specify a value between 1 and 100 in increments of 1, or set it to [No Limit]. The search
interval is 1 min. The default is [No Limit].