Filter
Top Products
4.2 Description of Menu Items 79
Print Unused Form
Specifies whether to cancel the job or to print data only if the form specified for printing is
not registered.
The default is [On (Data only)].
Default Paper Size
Specifies the default setting of the paper size when using E-mail printing feature, the paper
size when printing the reports, and the [Output Size] setting of the each print mode to [A4]
or [8.5×11"]. This default setting varies depending on the country where the printer is sold.
Allocate Memory
*3 (refer to P. 83)
[Allocate Memory] menu is used to change the capacity of the memory for each interface
and the form memory.
In this printer, you can change the following memory allocation.
• PS Memory
• HPGL auto layout memory
• Receive buffer memory
• Print page buffer
Important
• Changing the memory capacity will reset the memory and delete all data stored in each memory area.
• You cannot exceed the overall memory capacity during memory allocation. If the setting value exceeds
the actual memory capacity, the system will automatically adjust it at power on.
• If the memory is running out when the port is set to [Enable], the port may be disabled automatically. In
this case, you need to disable the port(s) you are not using or change the memory allocation. However,
the parallel and USB ports will not stop automatically.
Note
• The memory allocation settings (except the print page buffer setting) are available in the control panel
and OkiWebRemote.
• The print page buffer is the area in which the actual print image can be drawn. The print page buffer is
allocated to the remaining area after the memory is allocated to all other uses. Therefore, you cannot
directly change the print page buffer capacity. You can check the actual print page buffer size in [System
Settings List]. You can also check it in OkiWebRemote. When you want to print a high-resolution
document, allocate memory so that the print page buffer size is large.
PS
Specifies the memory capacity for PostScript.
Specify the memory capacity between 4.50 and 96.00 MB in increments of 0.25 MB. The
default is [12.00 M]. The maximum capacity you can set varies depending on the free
memory capacity.
HPGL Auto Layout
Specifies the memory capacity used for HP-GL, HP-GL/2 auto layout.
Specify the memory capacity between 64 and 5120 KB in increments of 32 KB. The default
is [64K]. The maximum capacity you can set varies depending on the free memory capacity.
If the hard disk (optional) is installed, the hard disk memory is used for the auto layout. You
cannot change its capacity. [Hard Disk] is displayed on the screen.