Filter
Top Products
64 4 Settings on the Control Panel
nAuto Eject Time
*3 (refer to P. 83)
Sets the time interval for the printer to automatically print the remaining data when no further
data is received for a continuous period.
The time can be set between 5 to 1275 seconds in increments of 5 seconds. The default is
[30 Secs]. When no data is received for the period specified here after the last data was
received, the printer determines it as job end.
nBaud rate
Sets the baud rate. Select from [9600bps] [19200bps] [38400bps] [57600bps] [115200bps]
[4800bps]. The default is [9600bps].
nStop Bit
Select the stop bit from [1 bit] or [2 bits]. The default is [1 bit].
nParity
Sets the parity. Select from [Not Available] [Odd] [Even]. The default is [Not Available].
nXON - XOFF Control
Sets whether to enable or disable the XON/XOFF control at the flow control. The default is
[On].
nDTR Control
Sets the DTR control from [Fix-High] [Fix-Low] [Active-High] [Active-Low]. The default is
[Fix-High].
LPD
Select this to use LPD.
nPort Status
Specifies whether to enable or disable the LPD port when the printer turns on. The default
is [Enable], which means the LPD port is available.
Note
• To enable the LPD port, the IP address must be set.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
nPrint Mode
*1 (refer to P. 83)
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [ESC/P] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type.
nPJL
*2 (refer to P. 83)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].