Filter
Top Products
20
2-1 Specifications
2-1-1 General Specifications
Item
CPM1A-10CDR-j
CPM1A-10CDT-D
CPM1A-10CDT1-D
CPM1A-20CDR-j
CPM1A-20CDT-D
CPM1A-20CDT1-D
CPM1A-30CDR-j
CPM1A-30CDT-D
CPM1A-30CDT1-D
CPM1A-40CDR-j
CPM1A-40CDT-D
CPM1A-40CDT1-D
Supply voltage
AC type 100 to 240 VAC, 50/60 Hz
DC type 24 VDC
Operating
AC type 85 to 264 VAC
voltage range
DC type 20.4 to 26.4 VDC
Power
AC type 30 VA max. 60 VA max.
consumption
DC type 6 W max. 20 W max.
Inrush current 30 A max. 38 A max.
External power
supply
Supply voltage 24 VDC
supply
(AC type only)
(see note)
Output capacity 200 mA 300 mA
Insulation resistance 20 MΩ min. (at 500 VDC) between the external AC terminals and protective earth
terminals
Dielectric strength 2,300 VAC 50/60 Hz for 1 min between the external AC and protective earth
terminals, leakage current: 10 mA max.
Noise immunity Conforms to IEC6100-4-4; 2 kV (power lines)
Vibration resistance 10 to 57 Hz, 0.075-mm amplitude, 57 to 150 Hz, acceleration: 9.8 m/s
2
in X, Y, and Z
directions for 80 minutes each
(Time coefficient; 8 minutes × coefficient factor 10 = total time 80 minutes)
Shock resistance 147 m/s
2
three times each in X, Y, and Z directions
Ambient temperature Operating: 0° to 55°C
Storage: –20° to 75°C
Humidity 10% to 90% (with no condensation)
Atmosphere Must be free from corrosive gas
Terminal screw size M3
Grounding
Less than 100 W
Power interrupt time AC type: 10 ms min.
DC type: 2 ms min.
(A power interruption occurs if power falls below 85% of the rated voltage for longer
than the power interrupt time.)
CPU Unit
AC type 400 g max. 500 g max. 600 g max. 700 g max.
weight
DC type 300 g max. 400 g max. 500 g max. 600 g max.
Expansion I/O Unit weight Units with 20 I/O points: 300 g max.
Units with 8 output points: 250 g max.
Units with 8 input points: 200 g max.
Expansion Unit weight Analog I/O Unit: 150 g max.
Temperature Sensor Units: 250 g max.
CompoBus/S I/O Link Unit:200 g max.
Note Use the external power supply as the service power supply of input devices. The
power supply cannot be used for driving output devices.
Specifications Section 2-1