- 197 -
Others
[Memory Card Error]/[Memory card parameter error]/[This memory card cannot be
used]
> Use a card compatible with this unit. (P20)
–SD Memory Card (8 MB to 2 GB)
–SDHC Memory Card (4 GB to 32 GB)
–SDXC Memory Card (48 GB, 64 GB)
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
> Remove the card after turning this unit off. Insert the card again, turn this unit on, and try to
read or write the data again.
•The card may be broken.
> Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the card]
•
Use a card with SD Speed Class with “Class 4” or higher when recording motion pictures.
•In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P54).
Depending on the type of the card, motion picture recording may stop in the middle.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
> Format the card after saving necessary data on a PC etc. (P54)
> Insert a different card.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc. (P54) If you execute [No.Reset] in the
[Setup] menu after formatting, the folder number is reset to 100. (P52)
[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]
•
Select [TVAspect] in the [Setup] menu if you want to change the TV aspect. (P53)
•This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P179, 183)
[Recording failed.]
•
You may not record when the recording location is too dark/too bright, or if the subject does not
have enough contrast when recording in 3D.