Filter
Top Products
9. Options
64
L All the registered handset numbers are
displayed and the pre-selected handset
number flashes.
7 Press the desired handset number(s).
L The selected handset number(s) will
flash.
L To cancel a selected handset number,
press the number again. The number will
stop flashing.
8 Press {>} or {j}.
9 Press {ih}.
Setting the selected handset(s) then all
handsets to ring
1 Press {j}.
2 Press {e} or {v} repeatedly to display
“SETTING BS”.
3 Press {>}.
L “INPUT CODE” will be displayed.
4 Press {1}.
5 Enter the 4-digit base unit PIN.
L The default PIN is “0000”.
6 Press {3} to select “3”.
L All the registered handset numbers are
displayed and the pre-selected handset
number flashes.
7 Press the desired handset number(s).
L The selected handset number(s) will
flash.
L To cancel a selected handset number,
press the number again. The number will
stop flashing.
8 Press {>}.
9 Press the desired number of rings for the
selected handset(s) from “1” to “6”, using the
dial keypad.
L The default setting is “3”.
L The selected number of rings will be
shown on the right edge of the display.
10 Press {>} or {j}.
11 Press {ih}.
9.4 Intercom between
handsets
You can use your handsets as a 2-way intercom.
L Keep the front cover page open for button
locations.
Example: When handset 1 calls handset 2
1. Handset 1:
Press {INT} and {2} (desired handset
number).
2. Handset 2:
Press {C} to answer.
3. When finished talking, press {ih}.
Note:
L Intercom calls can be conducted within the
radio cell of the current base unit, but not with
units in neighbouring radio cells.
9.5 Transferring calls
between
handsets/Conference call
Intercom can be used to transfer an external call
between handsets that are registered to the
same base unit.
L Keep the front cover page open for button
locations.
Example: When handset 1 transfers a call to
handset 2
1. Handset 1:
During an external call, press {INT} and {2}
(desired handset number).
L If there is no answer, press {INT} to return
to the external call.
2. Handset 2:
Press {C} to answer the page.
L Handset 2 can talk with handset 1.
L The external call will be put on hold.
3. Handset 1:
To complete the call transfer, press {ih}.
OR
To establish the conference call, press {3}.
To transfer a call directly, without speaking to
handset 2
After step 1, press {ih} on handset 1.
If the transferred call is not answered within 30
seconds, handset 1 will ring again.
FC195AL.book Page 64 Tuesday, November 18, 2003 10:28 AM