Filter
Top Products
8. Programmable Features
60
6. Press {>}.
7. Enter the 4-digit handset PIN.
L The default PIN is “0000”.
8. Press {e}.
9. Press {>} or {j}.
10.Press {ih}.
Note:
L Battery type selection (page 59) will not be
reset.
L The phonebook data (page 29) will be saved.
8.5 Handset programming
using the base unit PIN
To exit programming, press {ih} any time.
Changing base unit PIN
The base unit’s PIN is set at the factory to
“0000”. If you change the PIN, please write
down your new PIN as the unit will not reveal
the PIN to you. If you forget your PIN, consult
your nearest Panasonic service centre.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“SETTING BS”.
3. Press {>}.
L “INPUT CODE” will be displayed.
4. Press {5}.
5. Enter the current 4-digit base unit PIN.
6. Enter the new 4-digit base unit PIN.
7. Enter the new 4-digit base unit PIN again to
verify.
8. Press {ih}.
Setting call restriction
You can restrict selected handset(s) from dialling
selected phone numbers. You can assign up to
10 call restriction numbers (up to 8 digits). If you
dial a restricted number, the call will not be
connected and the restricted number will flash
on the display.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“SETTING BS”.
3. Press {>}.
L “INPUT CODE” will be displayed.
4. Press {6}.
5. Enter the 4-digit base unit PIN.
L The default PIN is “0000”.
L All the registered handset numbers are
displayed.
L If you programmed previously, the pre-
selected handset number flashes.
6. Press the desired handset number(s).
L The selected handset number will flash.
L To cancel the selected handset number,
press the number again. The number will
stop flashing.
7. Press {>}.
8. Enter the phone number to be restricted, up
to 8 digits.
L Do not enter the same number as
programmed for the fax activation code
(feature #41, page 53).
9. Press {>} or {j}.
L To enter other numbers, repeat steps 8
and 9 (up to 10 numbers).
10.Press {ih}.
Turning off/on call restriction
1. Press {j}.
2. Press {e} or {v} repeatedly to display
“SETTING BS”.
3. Press {>}.
L “INPUT CODE” will be displayed.
4. Press {6}.
5. Enter the 4-digit base unit PIN.
L The default PIN is “0000”.
6. Press the desired handset number.
L Handset numbers will be displayed.
Flashing numbers indicate call restriction
is on; non-flashing numbers indicate call
restriction is off. Press the desired
handset number to turn off/on.
7. Press {>} or {j}.
8. Press {ih}.
Cancelling a call restricted number
1. Press {j}.
{>}{e}{v}
{C}
{j}
{ih}
FC195AL.book Page 60 Tuesday, November 18, 2003 10:28 AM