Filter
Top Products
114 - ENGLISH
Chapter 5 Maintenance — Maintenance/replacement
Note
rf
The replacement cycle of the air lter unit varies greatly depending on the usage environment.
Lamp unit
The lamp unit is a consumable component. Check the lamp usage time in [PROJECTOR SETUP]
[STATUS] (
x
page 81) in the menu and
change the lamp periodically.
It is recommended that you request a qualied technician to replace the lamp unit. Consult your dealer.
Consult your dealer to purchase a replacement lamp unit (Model No.: ET-LAD60A (1 bulb), ET-LAD60AW (2 bulbs)).
Warning
rf
Replace the lamp unit after the lamp has cooled (after waiting at least one hour).
The high internal temperature of the cover will cause burns.
Notes on the replacement of the lamp unit
rf
Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object.
Please handle with care.
rf
A Phillips screwdriver is necessary when replacing the lamp unit.
rf
Make sure you hold the lamp unit by its handles during replacement.
rf
The lamp may burst. Replace the lamp unit carefully so that the broken pieces of the lamp glass will not scatter. If the projector is mounted
to the ceiling, do not make the replacement directly beneath the lamp unit or put your face near it.
rf
The lamp contains mercury. When disposing of used lamp units, contact your local authorities or dealer for correct methods of disposal.
Attention
rf
Use only specied lamp units.
Note
rf
The model numbers of accessories and optional components are subject to change without notice.
When to replace the lamp unit
The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary to replace it regularly. The
estimated duration before replacement is 2 000 hours. However, this may be shortened depending on individual lamp characteristics, usage
conditions, and the installation environment. Therefore, it is strongly recommended that a replacement lamp unit be prepared. If the lamp is not
replaced after 2 000 hours of use, a malfunction will occur and the projector will automatically switch off after approximately ten minutes.
On-screen display
REPLACE LAMP
Lamp indicator
Over 1 800 hours
The message is displayed for 30 seconds. Pressing
any button on the control panel or remote control
within 30 seconds will clear the message.
Lights in red even during the standby mode.
(Only the corresponding lamp lights)
Over 2 000 hours
The message remains displayed until you press a
button.
Note
rf
The 2 000 hour usage period is a rough estimate and is not guaranteed.
Replacing the lamp unit
Attention
rf
When the projector is mounted on the ceiling, do not perform tasks while your face is near the lamp unit.
rf
Make sure to attach the lamp unit and lamp unit cover properly.
rf
If the lamp unit is not installed properly, remove it and then attach it again. Pushing it in forcibly may break the connector.