Filter
Top Products
ENGLISH - 81
Chapter 4 Settings — [PROJECTOR SETUP] menu
6)
Press qw to switch [GROUP].
rf
The setting will change among [A] to [Z] each time you press
the button.
7)
Press as to select [RESPONSE(ID GROUP)].
8)
Press qw to switch [RESPONSE(ID GROUP)].
rf
The setting will change between [ON] and [OFF] each time you
press the button.
rr
[RESPONSE(ID ALL)]
[ON] Returns the response when the ID setting is ALL.
[OFF] Does not return the response when the ID setting is ALL.
rr
[GROUP]
[A] - [Z]
Controls multiple projectors simultaneously by sending the ID of RS-232C.
Set the group from [A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
rr
[RESPONSE(ID GROUP)]
[ON] Returns the response when the ID setting is GROUP.
[OFF] Does not return the response when the ID setting is GROUP.
Note
rf
Refer to “<SERIAL IN>/<SERIAL OUT> terminal” (
x
page 121).
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1)
Press as to select [REMOTE2 MODE].
2)
Press qw to switch [REMOTE2 MODE].
rf
The setting will change between [DEFAULT] and [USER] each
time you press the button.
rf
When [USER] is selected, proceed to Step 3).
3)
Press the <ENTER> button.
4)
Press as to select any from [PIN2] to [PIN8]
and press qw to switch the setting.
rf
[PIN1] and [PIN9] cannot be changed.
rr
[REMOTE2 MODE]
[DEFAULT]
The pin assignment of the <REMOTE 2 IN> terminal is used by the factory default setting of the projector.
(
x
page 124)
[USER]
The pin assignment of the <REMOTE 2 IN> terminal is used by the setting changed from the factory default
setting of the projector.
[STATUS]
Displays the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
rf
The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
rf
The page will change each time you press the button.
rr
Contents to be displayed
[INPUT] Displays the input terminal currently selected.
[SIGNAL NAME] Displays the input signal name.
[SIGNAL FREQUENCY] Displays the frequency of the input signal.
[PROJECTOR RUNTIME] Displays the operation times of the projector.
[LAMP1]
*
Displays the hours used of lamp 1.
[LAMP2]
*
Displays the hours used of lamp 2.
[INTAKE AIR TEMP.] Displays the status of the air intake temperature of the projector.
[OPTICS MODULE TEMP.] Displays the status of the internal temperature of the projector.
[AROUND LAMP TEMP.] Displays the status of the temperature around the lamps of the projector.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[LAMP UNIT MODEL NO.] Displays the model no. of the lamp unit.