Filter
Top Products
ENGLISH - 69
Chapter 4 Settings — [DISPLAY OPTION] menu
5)
Press the <ENTER> button.
rf
The [MEASURED DATA] screen is displayed.
6)
Measure the current luminance (Y) and the
chromaticity coordinates (x, y) using the
colorimeter.
7)
Press as to select a color, then press qw to
adjust the value.
8)
Once all the input is completed, press the
<MENU> button.
rf
The [MEASURED MODE] screen is displayed.
9)
Press as to select [TARGET DATA].
10)
Press the <ENTER> button.
rf
The [TARGET DATA] screen is displayed.
11)
Press as to select a color, and press qw to
input coordinates for desired colors.
12)
Once all the input is completed, press the
<MENU> button.
Note
rf
Colors are not displayed properly when target data is a color outside the region of this projector.
rf
Set the [AUTO TESTPATTERN] to [ON] to automatically display a test pattern for use in adjusting the selected adjustment colors.
rf
When using a colorimeter or similar instrument to measure measurement data, measure the colors displayed with [AUTO TESTPATTERN].
rf
A difference in the color coordinates of target data and measurement values obtained from an instrument may occur for certain instruments
and measurement environments used.
[COLOR CORRECTION]
Colors can be adjusted and registered for each input signal format.
1)
Press as to select [COLOR CORRECTION].
2)
Press qw to switch [COLOR CORRECTION].
rr
[COLOR CORRECTION]
[OFF] Standard setting
[USER]
For each of the four signal formats, VIDEO, S-VIDEO, RGB, and YC
B
C
R
/YP
B
P
R
, six colors including red,
green, blue, cyan, magenta, and yellow can be adjusted and registered. Press the <ENTER> button to set
details. The adjustment range is between
-
30 and +30.
[CONTRAST MODE]
There are two modes. Set according to the operating environment.
1)
Press as to select [CONTRAST MODE].
2)
Press qw to switch [CONTRAST MODE].
rr
[CONTRAST MODE]
[NORMAL] Maximizes brightness.
[HIGH] Maximizes contrast.
[SCREEN SETTING]
Set the screen size.
When changing the aspect of a projected image, correct to the optimum image position for the set screen. Set as necessary for the screen in
use.
1)
Press as to select [SCREEN SETTING].
2)
Press the <ENTER> button.
rf
The [SCREEN SETTING] screen is displayed.
3)
Press qw to switch [SCREEN FORMAT].
rf
The setting will change between [16:10] and [16:9] for
PT-DW740U, or [4:3] and [16:9] for PT-DX810U.
4)
Press as to select [SCREEN POSITION].
5)
Press qw to adjust [SCREEN POSITION].
rr
[SCREEN FORMAT]
PT-DW740U
[16:10]
[SCREEN POSITION]
Cannot be adjusted.
[16:9]
Vertical position can be adjusted between
-
40 and
40.
PT-DX810U
[4:3] Cannot be adjusted.
[16:9]
Vertical position can be adjusted between
-
96 and
96.