Filter
Top Products
94 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
Name and function of network function parts
1 2 3
1 LAN10/100 lamp (yellow)
Lights on when connected to the 100BASE-TX.
2 <LAN> terminal (10BASE-T/100BASE-TX)
Used to connect the LAN cable here.
3 LAN LINK/ACT lamp (green)
Lights on when connected.
Flashes when transmitting/receiving data.
Attention
rf
Connect the LAN to indoor devices.
Accessing from the Web browser
1)
Start up the Web browser on the computer.
2)
Enter the IP address set on the projector into
the URL entry field of the Web browser.
3)
Enter the user name and the password.
rf
The factory default setting of the user name is user1 (user
rights)/admin1 (administrator rights) and the password is
panasonic (lower case).
4)
Click OK.
rf
The [Projector status] page is displayed.
Note
rf
If you use a Web browser to control the projector, set [WEB CONTROL] to [ON] in [NETWORK CONTROL] (
x
page 92).
rf
Do not perform setting or control simultaneously by starting up multiple Web browsers. Do not set or control the projector from multiple
computers.
rf
Change the password rst. (
x
page 104)
rf
The administrator rights allows to use all functions. The user rights allow use of [Projector status] (
x
page 95), conrmation of the error
information page (
x
page 96), [Network status] (
x
page 97), [Basic control] (
x
page 98), and [Change password] (
x
page 104)
only.
rf
Access will be locked for few minutes when an incorrect password is entered three times consecutively.