Filter
Top Products
62 - ENGLISH
Chapter 4 Settings — [POSITION] menu
Note
rf
When [ASPECT] is set to [THROUGH], [ZOOM] is not displayed.
When [ASPECT] is set to [DEFAULT]
1)
Press as to select [ZOOM].
2)
Press the <ENTER> button.
rf
The [ZOOM] screen is displayed.
3)
Press as to select [MODE].
4)
Press qw to switch [MODE].
5)
Press as to select [INTERLOCKED].
6)
Press qw to switch [INTERLOCKED].
7)
Press as to select [VERTICAL] or
[HORIZONTAL].
rf
Select [BOTH] when [ON] is selected.
8)
Press qw to adjust.
rr
[MODE]
[INTERNAL] Enlarges the size within the aspect range set with [SCREEN FORMAT].
[FULL] Enlarges the size to the entire display area set with [SCREEN FORMAT].
rr
[INTERLOCKED]
[OFF]
[VERTICAL]
Set the [VERTICAL] and [HORIZONTAL] zoom ratio.
[HORIZONTAL]
[ON] [BOTH]
Use [BOTH] to set zoom ratio. Horizontal and vertical can be expanded
by units of 1.0 time.
Note
rf
When [ASPECT] is set to other than [DEFAULT], [MODE] is not displayed.
[CLOCK PHASE]
You can adjust to achieve an optimal image when there is a ickering image or smeared outlines.
1)
Press as to select [CLOCK PHASE].
2)
Press qw or the <ENTER> button.
rf
The [CLOCK PHASE] individual adjustment screen is
displayed.
3)
Press qw to adjust.
rf
Adjustment value will change between 0 and +31. Adjust so that
the amount of interference is at a minimum.
Note
rf
Optimal value may not be achieved if the output from the input computer is unstable.
rf
Optimal value may not be achieved when there is a shift in the total dot numbers.
rf
[CLOCK PHASE] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
rf
[CLOCK PHASE] cannot be adjusted when a digital signal is input.
rf
If you press
w
while the adjustment value is [+31], the value will become [0]. If you press
q
while the adjustment value is [0], the value will
become [+31].