Filter
Top Products
ENGLISH - 59
Chapter 4 Settings — [PICTURE] menu
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1)
Press as to select [SYSTEM SELECTOR].
2)
Press the <ENTER> button.
3)
Press as to select a system format.
4)
Press the <ENTER> button.
rr
Available system formats
Terminals System format
<VIDEO IN> terminal,
<S-VIDEO IN> terminal
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL], [PAL-M],
[PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used. NTSC signal method is used in Japan.
<RGB 1 IN> terminal,
<RGB 2 IN> terminal
480i, 576i, or 576p signal Select [RGB] or [YC
B
C
R
].
VGA60 or 480p signal Select [VGA60], [480p], or [480pRGB].
Other movie based signals Select [RGB] or [YP
B
P
R
].
<DVI-D IN> terminal
480p or 576p signal Select [RGB] or [YC
B
C
R
].
Other movie based signals Select [RGB] or [YP
B
P
R
].
<HDMI IN> terminal
480p or 576p signal Select [AUTO], [RGB], or [YC
B
C
R
].
Other movie based signals Select [AUTO], [RGB], or [YP
B
P
R
].
Note
rf
Refer to “List of compatible signals” (
x
page 125) for compatible signals.
rf
This may not function properly for some external devices that are connected.