Filter
Top Products
82 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
[LAMP1 SERIAL NUMBER] Displays the serial number of the lamp 1.
[LAMP2 SERIAL NUMBER] Displays the serial number of the lamp 2.
[MAIN VERSION] Displays the main version of the rmware of the projector.
[SUB VERSION] Displays the sub version of the rmware of the projector.
[NETWORK VERSION] Displays the network version of the projector.
[ON COUNT]
[POWER ON TIMES] Displays the number of times the power is turned on.
[LAMP1 ON] Displays the number of times lamp 1 has been turned on.
[LAMP2 ON] Displays the number of times lamp 2 has been turned on.
[SHUTTER] Displays the number of times the shutter function has been used.
[LAMP1] Displays the details of cumulative operating time.
[LAMP2] Displays the details of cumulative operating time.
[NUMBER OF ENTRY SIGNAL] Displays the number of registered signals.
[REMOTE2 STATUS] Displays the control status of the REMOTE2.
[SIGNAL INFORMATION]
[MEMORY NO.] Displays the memory number of the input signal.
[INPUT] Displays the input terminal currently selected.
[SIGNAL NAME] Displays the input signal name.
[SIGNAL FREQUENCY] Displays the frequency of the input signal.
[SYNC.STATE] Displays the synch polarity of the input signal.
[V.SYNC WIDTH] Displays the vertical sync signal pulse width of the input signal.
[SCAN TYPE] Displays the scan type of the input signal.
[TOTAL DOTS] Displays the total dot count of the input signal.
[DISPLAY DOTS] Displays the number of input signal display dots.
[TOTAL LINES] Displays the total line count of the input signal.
[DISPLAY LINES] Displays the number of input signal display lines.
[SAMPLING] Displays the sampling information of the input signal.
* Displays the actual time for the hours used of lamp.
To calculate a rough guide for lamp replacement, convert as follows:
Lamp replacement time =
Cumulative operating time when [LAMP POWER] is set to [NORMAL] + (Cumulative operating time when [LAMP POWER] is set to [ECO] x
2/3)
Note
rf
The content of status can be sent via E-mail by pressing the <ENTER> button while displaying the status.
rf
Some items in [SIGNAL INFORMATION] may be displayed and others not displayed, depending on the signal being input.
[NO SIGNAL SHUT-OFF]
You can set the power of the projector automatically to standby if there is no input signal by the specied time.
1)
Press as to select [NO SIGNAL SHUT-OFF].
2)
Press qw to switch [NO SIGNAL SHUT-OFF].
rr
[NO SIGNAL SHUT-OFF]
[DISABLE] Disables the No signal shut-off function.
[10MIN.] - [90MIN.] Allows you to set in ten minutes intervals.
[FUNCTION BUTTON]
Set the functions of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
rf
The [FUNCTION BUTTON] screen is displayed.
3)
Press as to select a function.
4)
Press the <ENTER> button.
rr
Available functions
[DISABLE] Disables the <FUNCTION> button.
[SUB MEMORY] Switches the sub memory. (
x
page 87)
[SYSTEM SELECTOR] Switches the [SYSTEM SELECTOR] setting. (
x
page 59)