Filter
Top Products
Chapter 1 Preparation — About your projector
ENGLISH - 21
r
Control panel
3
4
1
2
1 Power <
v
/
b
> button
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode. Also sets the
projector in projection mode when the power is switched off
(standby mode).
2 <MENU> button
Displays the main menu.
3 <INPUT SELECT> button
Switches the input signal to project. (
x
page 38)
4
asqw
buttons/<RETURN> button/<ENTER> button
Used to navigate through the menu screen.
Also used to enter a [SECURITY] password or character input.
r
Connecting terminals
1 2 3 4 5
876
1 <DIGITAL LINK/LAN> terminal
This is the LAN terminal to connect to the network. This is
also used when connecting an audio and video signal sending
device via the LAN terminal.
2 <HDMI IN> terminal
This is the terminal to input HDMI signals.
3 <DVI-I IN> terminal
This is the terminal to input DVI-D and DVI-A signals (RGB
signals or YC
B
C
R
/YP
B
P
R
).
4 <COMPUTER IN> terminal
This is the terminal to input RGB or YC
B
C
R
/YP
B
P
R
signals from
a computer.
5 <VIDEO IN> terminal
This is the terminal to input video signals.
6 <AUDIO IN> terminal
This is the terminal to input audio signals.
7 <VARIABLE AUDIO OUT> terminal
This is the terminal to output audio signals input to the projector.
8 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
Attention
f
When a LAN cable is directly connected to the projector, the network connection must be made indoors.