Filter
Top Products
Chapter 4 Settings — [NETWORK] menu
90 - ENGLISH
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1)
Press as to select [NETWORK SETUP].
2)
Press the <ENTER> button.
f
The [NETWORK SETUP] screen is displayed.
3)
Press as to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME] Change the setting when using a DHCP server.
[DHCP]
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
[IP ADDRESS] Enter the IP address when not using a DHCP server.
[SUBNET MASK] Enter the subnet mask when not using a DHCP server.
[DEFAULT GATEWAY] Enter the default gateway address when not using a DHCP server.
4)
Press as to select [STORE], and press the <ENTER> button.
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
Note
f
When using a DHCP server, conrm that the DHCP server is running.
f
Consult your network administrator regarding the IP address, subnet mask, and default gateway.
[NETWORK CONTROL]
Set up the control method of the network.
1)
Press as to select [NETWORK CONTROL].
2)
Press the <ENTER> button.
f
The [NETWORK CONTROL] screen is displayed.
3)
Press as to select an item, and press qw to change the setting.
[WEB CONTROL] Set to [ON] to control with the web browser.
[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.
[COMMAND CONTROL]
Set to [ON] when controlling the projector with a <SERIAL IN> terminal control command format
(
x
page 120).
Refer to “Control commands via LAN” (
x
page 116).
[COMMAND PORT] Set the port number used for command control.
[CRESTRON RoomView] Set to [ON] to control with RoomView of Crestron.
[AMX D.D.]
Set to [ON] to control with the controller of AMX.
Setting this function to on enables detection with AMX device discovery. For details, refer to the
website of AMX.
URL http://www.amx.com/
[EXTRON XTP]
Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
[EXTRON XTP] must be set to [OFF] when connecting an optional digital interface box (Model No.:
ET-YFB100G).
For details of “XTP transmitter”, refer to the website of Extron Electronics.
URL http://www.extron.com/
[STORE] Save the current network control settings.
4)
Press as to select [STORE], and press the <ENTER> button.
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.