Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
34 - ENGLISH
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
3)
2)1)
2)
1)
4)
1)
Set the initial settings. (x page 18)
f
The initial setting screen is displayed when the projector is switched on for the rst time after purchase as well as when [ALL USER
DATA] (
x
page 81) in [INITIALIZE] is executed.
2)
Press the input selection (<COMPUTER>, <DVI-I>, <VIDEO>, <DIGITAL LINK>, <HDMI>) buttons to
select the input signal. (x page 38)
3)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 26)
4)
If the input signal is an RGB input signal, press the <AUTO SETUP> button. (x page 38)
Switching off the projector
1)
3)
2)
4)
1) 2)
1)
Press the power <v/b> button.
f
The [POWER OFF(STANDBY)] conrmation screen is displayed.
2)
Press qw to select [OK], and press the <ENTER> button.
(Or press the power <
v
/
b
> button again.)
f
Projection of the image stops.
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
flashes in red.
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
The projector consumes power if the main power of the projector is on, even when the power <
v
/
b
> button is pressed and the
power is switched off.
When the [STANDBY MODE] menu (
x
page 71) is set to [ECO], the power consumption during standby can be conserved.
f
The power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch while projecting or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while mounting on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reected.