Filter
Top Products
Chapter 4 Settings — [NETWORK] menu
ENGLISH - 89
7)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
Note
f
Not compatible with 10BaseT Full/Half.
When the projector is connected directly via a twisted-pair-cable transmitter
1)
Press as to select [DIGITAL LINK SETUP].
2)
Press the <ENTER> button.
f
The [DIGITAL LINK SETUP] screen is displayed.
3)
Press as to select [DUPLEX(DIGITAL LINK)].
4)
Press qw to switch the communication method.
f
The items will switch each time you press the button.
[100BaseTX-Full] Full duplex communication method is set.
[100BaseTX-Half] Half-duplex communication method is set.
[AUTONEGOTIATION] The communication method is set automatically.
5)
Press as to select [STORE].
6)
Press the <ENTER> button.
7)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[DIGITAL LINK STATUS]
Display DIGITAL LINK connection environment.
1)
Press as to select [DIGITAL LINK STATUS].
2)
Press the <ENTER> button.
f
The [DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS] Display [NO LINK], [DIGITAL LINK], or [ETHERNET].
[HDMI STATUS] Display any one of [NO HDMI], [HDMI ON], or [HDCP ON].
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on the value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
MAX/MIN: Maximum/minimum value of the amount of error.
f
Green (
-
12 dB or lower)
→
Normal signal quality level.
f
Yellow (
-
11 to
-
8 dB)
→
Warning level where there is the possibility of noise introduced on the
screen.
f
Red (
-
7 dB or higher)
→
Abnormal level where synchronization may interrupted, or a signal may
not be received.