Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
80 - ENGLISH
Setting the date and time automatically
1)
Press as to select [DATE AND TIME].
2)
Press the <ENTER> button.
f
The [DATE AND TIME] screen is displayed.
3)
Press as to select [ADJUST CLOCK].
4)
Press the <ENTER> button.
f
The [ADJUST CLOCK] screen is displayed.
5)
Press as to select [NTP SYNCHRONIZATION], and press qw to change the setting to [ON].
f
The items will switch each time you press the button.
[OFF] Disables [NTP SYNCHRONIZATION].
[ON] Enables [NTP SYNCHRONIZATION].
6)
Press as to select [APPLY], and press the <ENTER> button.
f
The setting of the time will be completed.
Note
f
To set the date and time automatically, the projector must be connected to the network.
f
If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is turned [ON], or if [NTP SYNCHRONIZATION] is turned
[ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].
f
Access the projector via the web browser to set the NTP server. Refer to “[Adjust clock] page” (
x
page 98) for details.
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1)
Press as to select [SAVE ALL USER DATA].
2)
Press the <ENTER> button.
f
The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
f
[PROGRESS] is displayed while saving data.
Note
f
The image setting registered in [USER LOGO] is not saved.
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f
The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
4)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
Note
f
The projector will go into the standby status to reect the setting values when [LOAD ALL USER DATA] is executed.