Filter
Top Products
Chapter 2 Getting Started — Connecting
28 - ENGLISH
<HDMI IN> terminal pin assignments and signal names
Outside view Pin No. Signal name Pin No. Signal name
Even-numbered pins (2) to (18)
(1) (19)
(2) (18)
Odd-numbered pins (1) to (19)
(1) T.M.D.S data 2+ (11) T.M.D.S clock shield
(2) T.M.D.S data 2 shield (12) T.M.D.S clock
-
(3) T.M.D.S data 2
-
(13) CEC
(4) T.M.D.S data 1+ (14) —
(5) T.M.D.S data 1 shield (15) SCL
(6) T.M.D.S data 1
-
(16) SDA
(7) T.M.D.S data 0+ (17)
DDC/CEC
GND
(8) T.M.D.S data 0 shield (18) +5 V
(9) T.M.D.S data 0
-
(19) Hot plug detection
(10) T.M.D.S clock+
Connecting example: AV equipment
'9'SOD\HUZLWK+'0,
WHUPLQDO+'&3
9&5ZLWKEXLOWLQ7%&
%OXUD\GLVFSOD\HU
$XGLRGHYLFH
Attention
f
Always use one of the following when connecting a VCR.
g
A VCR with built-in time base corrector (TBC)
g
A time base corrector (TBC) between the projector and the VCR
f
If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between the
projector.
f
Use a commercial HDMI/DVI conversion cable with a ferrite core.
Note
f
The <DVI-I IN> terminal can be connected to HDMI- or DVI-I-compliant devices. However, images may not appear or may not be displayed
properly on some devices. (
x
page 62)
f
For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standards
is used, images may be interrupted or not displayed, or the projector may not function properly.
f
The <HDMI IN> terminal of the projector can be connected to an external device with an DVI terminal by using an HDMI/DVI conversion
cable, but some devices may not project the image properly or function properly. (
x
page 63)
f
When DVI-I is input, some external devices to be connected may require EDID to be set. (
x
page 62)
f
The projector does not support VIERA Link (HDMI).
f
If the [AUDIO IN SELECT] settings are incorrect, the projector may not output audio or otherwise function properly. (
x
page 78)