Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
70 - ENGLISH
[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following gure. Using the light source with
incorrect settings may shorten its life.
>9(57,&$/
836(77,1*@
>)/2256(77,1*@
>&(,/,1*6(77,1*@
>9(57,&$/
'2:16(77,1*@
3URMHFWLRQGLUHFWLRQ
1)
Press as to select [COOLING CONDITION].
2)
Press the <ENTER> button.
f
The [COOLING CONDITION] screen is displayed.
3)
Press as to select a cooling condition.
4)
Press the <ENTER> button.
5)
When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[ECO MANAGEMENT]
A function that optimizes the light source power to suit usage conditions to reduce power consumption.
Setting [LIGHT POWER]
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [LIGHT POWER].
4)
Press qw to switch [LIGHT POWER].
f
The items will switch each time you press the button.
[NORMAL] Set when high luminance is required.
[ECO SAVE1]
Reduces average power by approximately 20 % compared to [NORMAL] without affecting the
brightness.
[ECO SAVE2]
Reduces average power by approximately 30 % compared to [NORMAL] without affecting the
brightness.
[LOW] Set when high luminance is not required and you want to save more power.
Note
f
The rate of reduction of power consumption when the eco save mode is set refers to the ratio of average power consumption when
projecting a “Broadcast” video signal that complies with IEC62087.
f
When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].
f
If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image.
f
When [LOW] is set, the operating noise can be reduced.
f
When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set while
selecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.
f
When [PICTURE MODE] is [NATURAL] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to sRGB
standards.
f
When [PICTURE MODE] is [REC709] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to REC709
standards.
f
When [PICTURE MODE] is [DICOM SIM.] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may be displayed different
from DICOM standards.